AQUADECKS
Waterborne saturing finish for all woods interior and exterior
 Multicoat coverage: 5 m²/L - Coverage rate for maintenance: 10 to 12 m²/L |
 Application temperature: +10°C à +30°C |
 Drying: 4 hours |
PROPERTIES
Water based
Apply to new or weathered wood
Ready to use - Easy Application
Non-film Forming - No Peeling, No Flaking,
Excellent weather resistance
Use on Horizontal & Vertical surfaces: decks, outdoor furniture, cladding,...
Excellent UV protection
Low odour. Quick drying
Easy maintenance, no sanding, no stripping
WHERE TO USE
- For exterior or interior use.
- Tropical Hardwoods : Teak, Ipe, Cumaru, Bangkirai, Movingui, Massaranduba...
- Softwoods : Pine, Spruce, Cedar, Larch, Pressure Treated wood...
- Thermo wood and Broad leaved woods (Oak, Ash, Beech, Maple....)
- Direct on prepared woods
RECOMMENDATIONS BEFORE Application
- Surfaces must be thoroughly clean, dry and free of dirt, grease, grime, mildew and previous coatings
- Wood must be dry (max. 18% moisture content)
- Do not apply in direct sunlight or to hot surfaces.
- Do not apply if cold and/or wet weather is expected within 12 hours. Be aware of early morning dew.
- Cover everything you do not wish to coat, including plants and shrubs.
- Ensure timber if free of all factory applied sealens or finishes.
- OWATROL recommendation: some untreated softwoods may need to be treated with a preservative (SANIXYL) to protect against possible fungal attack or blue stain
Application
- Mix thoroughly before and periodically during application. Do not thin.
- Apply a liberal application of AQUADECKS working in direction of grain and working an area that you can complete in 30 min.
- Apply 2nd application as soon as wet look of 1st application has disappeared and allow to penetrate (15 - 20 minutes)
- Wipe up any excess that has not penetrated or brush out to areas where product has penetrated, in order to avoid AQUADECKS drying as shiny spots on the surface. AQUADECKS place is in the wood not on the surface.
- After spray application, always back-brush or back-roll to improve penetration, coverage and uniformity of color.
- Do not allow to become Touch Dry or Dry between applications
Proud Members of International Thermo Wood Association 
- Site created by adfields.solutions
© OWATROL - Groupe DURIEU - 29 avenue du Roule - 92200 Neuilly s/Seine (France) - Phone: +33 (0)1 82 88 83 65 - Fax : +33 (0) 160 86 84 84