Does not contain solvent or paraffin - non flammable.
Strips waxes, varnish, paint and most antifouling paint.
Coating becomes soluble with water (rinse with water).
Strips up to 8 coats of paint in 1 application.
Easy to apply, even on the most difficult surfaces to strip i.e. ornate or elaborate.
Does not evaporate - will not dry.
Works alone - does not require supervision or immediate removal of the softened paint.
WHERE TO USE
Use on wood (Except Oak, Chestnut, Parquet and Veneer), metal (except Aluminum), plastic, stone, cement ...
Ideal for surfaces difficult to strip or very ornate, horizontal and vertical - doors, gates, barriers ...
Recommended for stripping large areas - non-flammable, does not dry out, remains active a long time.
Does not attack plastics, rubber, synthetic coating or gel coats (GRP).
RECOMMENDATIONS BEFORE Application
Always test a small area first.
Wear protective gloves - rubber, nitrile. Use nylon/synthetic brushes.
Working time for stripping the finish varies from minutes to hours depending on the type of finish being removed (oil-based or water-based) and number of coats. Occasionaly check the stripping action, to establish when full removal of the finish(s) can be performed.
Always neutralise surface with NET-TROL after stripping.
Application
Apply a thick layer of DILUNETT to surface to be stripped.
Allow to stand.
If DILUNETT starts to dry, apply a fine mist of water to keep active.
Scrub surface with stiff nylon brush and rinse with water using the highest pressure source available or use a pressure washer (max. 60 bar).
Using hot water makes stripping easier.
After stripping wood, always neutralise with NET-TROL, immediately after rinsing the DILUNETT.