pack-dilunett-SK

DILUNETT no

Løsemiddelfri malingsfjerner for alle overflater
picto_rendement Coverage: 4 m²/l
picto_temperature Application temperature: +5°C to +35°C
picto_temps Working time: 5 mn to 12 h.

picto_eau-Gb

PROPERTIES

Does not contain solvent or paraffin - non flammable.
Strips waxes, varnish, paint and most antifouling paint.
Coating becomes soluble with water (rinse with water).
Strips up to 8 coats of paint in 1 application.
Easy to apply, even on the most difficult surfaces to strip i.e. ornate or elaborate.
Does not evaporate - will not dry.
Works alone - does not require supervision or immediate removal of the softened paint.

WHERE TO USE

  • Use on wood (Except Oak, Chestnut, Parquet and Veneer), metal (except Aluminum), plastic, stone, cement ...
  • Ideal for surfaces difficult to strip or very ornate, horizontal and vertical - doors, gates, barriers ...
  • Recommended for stripping large areas - non-flammable, does not dry out, remains active a long time.
  • Does not attack plastics, rubber, synthetic coating or gel coats (GRP).

RECOMMENDATIONS BEFORE Application

  • Always test a small area first.
  • Wear protective gloves - rubber, nitrile. Use nylon/synthetic brushes.
  • Working time for stripping the finish varies from minutes to hours depending on the type of finish being removed (oil-based or water-based) and number of coats. Occasionaly check the stripping action, to establish when full removal of the finish(s) can be performed.
  • Always neutralise surface with NET-TROL after stripping.

Application

  • Apply a thick layer of DILUNETT to surface to be stripped.
  • Allow to stand.
  • If DILUNETT starts to dry, apply a fine mist of water to keep active.
  • Scrub surface with stiff nylon brush and rinse with water using the highest pressure source available or use a pressure washer (max. 60 bar).
  • Using hot water makes stripping easier.
  • After stripping wood, always neutralise with NET-TROL, immediately after rinsing the DILUNETT.
  • Refer to packaging for full instructions.

our Advice

  • Using hot water makes stripping easier.

 

 

 

Related Products

pack-net-trol-SK

MAST RESTORER no

Trerens & Fargefornyer
pack-rustol-owatrol-SK

OWATROL OLJE no

Fargeløs, penetrerende og isolerende rustbeskyttende olje
pack-polytrol-SK

POLYTROL no

Fargefornyer - Plastikk, Maling, GRP, Metall