DEKS OLJE D.1
Saturating Wood Oil for Interior and Exterior Tropical Woods
 Coverage rate for maintenance: 8 to 12 m²/l - Multicoat coverage: 1 to 4 m²/l |
 Application temperature: +5°C to +35°C |
 Drying: 24 h. - Setting up time before use: 3 days |
PROPERTIES
Can be applied to both horizontal or vertical surfaces.
Saturates and protects all woods - Soft and Hard ; Oily and Dense.
Excellent penetration - non-film forming.
Replaces the natural oils lost from the wood - will not blacken the timber .
Transparent - Enhances the woods natural grain.
Deep penetrating, stabilises the timber - Protects against moisture ingress.
Easy maintenance - no sanding or stripping.
Used alone, gives a silken matt finish or overcoat with DEKS OLJE D2 for a high gloss finish.
WHERE TO USE
- Hardwoods and Tropical Timber : Oak, Chestnut, Teak, Mahogany, Movingui, Ipe, Bangkirai ...
- Softwoods : Pine, Spruce, Larch ...
- Exterior : garden furniture, patios, walkways, boat decks, topsides on boats, portals ...
- Interior : flooring, paneling, stairs, doors, windows, door frames ...
- Marine : Can be applied above or below the waterline. Excellent primer for conventional single pack marine coatings.
- Direct on prepared woods
- Horizontal - Vertical.
Application
- Apply a coat of DEKS OLJE D.1 - Allow to penetrate for 15-30 minutes.
- Apply a second application. Allow to penetrate for 15-30 minutes.
- Repeat this procedure until the wood is saturated i.e. will accept no more oil.
- Once the timber is saturated, always brush out or wipe up any excess product that has not penetrated to avoid shiny spots.
- Do not allow DEKS OLJE D.1 to become touch dry or dry between coats (apply "wet on wet").
- Refer to the packaging for maintenance procedure.
Related Products
Proud Members of International Thermo Wood Association 
- Site created by adfields.solutions
© OWATROL - Groupe DURIEU - 29 avenue du Roule - 92200 Neuilly s/Seine (France) - Phone: +33 (0)1 82 88 83 65 - Fax : +33 (0) 160 86 84 84