BAFGBJ
Reference : BAFGBJen
:
- :
TVA 19.6%19.6%
CONDITION : Stained or coated with an acrylic finish
DESIRED FINISH : Stain
SUPPORT : Wood
SITUATION : Exterior
TYPE : Thermowood
EXPLICATIF : Ensure weather conditions are compatible with application of the product.
The surface must be clean, dry and in sound condition.
PREPARATION: 3 options available for stripping back to bare wood: 1- Apply undiluted PREPDECK to dry wood. Allow it to work 10-30min max. Scrub and rinse thoroughly with fresh water. After rinsing, if TROPITECH is the chosen finish, apply on the wet wood. If you go for a different finish, neutralise the wood with NET-TROL. Scrub and rinse thoroughly with fresh water and allow to dry 3 good drying days before applying the finish. 2- Apply DSP 800. Allow it to work according to test previously conducted to strip finish. When the coating curls or softens, remove finish with a scraper or a nylon scrubbing brush. Rinse the surface with warm water, acetone or white spirit to remove any wax residue. 3-Sand the surface. Finish by sanding with 80/100 grit max. Thoroughly dust off.
APPLICATION: Thoroughly stir TEXTROL NACRE and apply one coat. Allow to dry 3-4 hours, Apply second coat. Do not allow more than 36 hours between coats. Allow to dry 24 hours.
The surface must be clean, dry and in sound condition.
PREPARATION: 3 options available for stripping back to bare wood: 1- Apply undiluted PREPDECK to dry wood. Allow it to work 10-30min max. Scrub and rinse thoroughly with fresh water. After rinsing, if TROPITECH is the chosen finish, apply on the wet wood. If you go for a different finish, neutralise the wood with NET-TROL. Scrub and rinse thoroughly with fresh water and allow to dry 3 good drying days before applying the finish. 2- Apply DSP 800. Allow it to work according to test previously conducted to strip finish. When the coating curls or softens, remove finish with a scraper or a nylon scrubbing brush. Rinse the surface with warm water, acetone or white spirit to remove any wax residue. 3-Sand the surface. Finish by sanding with 80/100 grit max. Thoroughly dust off.
APPLICATION: Thoroughly stir TEXTROL NACRE and apply one coat. Allow to dry 3-4 hours, Apply second coat. Do not allow more than 36 hours between coats. Allow to dry 24 hours.
DESIRED APPEARANCE : Mother of Pearl Grey
Proud Members of International Thermo Wood Association 
- Site created by adfields.solutions
© OWATROL - Groupe DURIEU - 29 avenue du Roule - 92200 Neuilly s/Seine (France) - Phone: +33 (0)1 82 88 83 65 - Fax : +33 (0) 160 86 84 84