AAEACB
Reference : AAEACBen
:
- :
TVA 19.6%19.6%
CONDITION : New and bare
DESIRED FINISH : Floor varnish
SUPPORT : Wood
SITUATION : Interior
TYPE : European wood
EXPLICATIF : Ensure the room is well ventilated during and after application.
The surface must be clean, dry and in sound condition.
PREPARATION: Conduct a water drop test: sprinkle a few drops of water on the surface. If water penetrates quickly the finish can be applied. If the water sits on the surface or beads up then the grain of the wood is not sufficienlty open to apply the finish. It is then necessary to prepare it by sanding the wood with (grit 80/100 max) abrasive and thoroughly dust off.
APPLICATION:: 2 options available: 1- One component finish : Thoroughly stir VEGAFLOOR and apply an even generous coat. Allow to dry 3-4 hours. Lightly sand the surface and dust off. Apply second coat. Do not leave more than 12 hours between the 1st and 2nd coat. 2- Two component finish : mix 1 part of UFL hardener to 10 parts of ULTIMAFLOOR. After 5min apply an even generous coat. Allow to dry 4 hours. Lightly sand the surface and dust off. Apply second coat. Do not leave more than 12 hours between the 1st and 2nd coat
The surface must be clean, dry and in sound condition.
PREPARATION: Conduct a water drop test: sprinkle a few drops of water on the surface. If water penetrates quickly the finish can be applied. If the water sits on the surface or beads up then the grain of the wood is not sufficienlty open to apply the finish. It is then necessary to prepare it by sanding the wood with (grit 80/100 max) abrasive and thoroughly dust off.
APPLICATION:: 2 options available: 1- One component finish : Thoroughly stir VEGAFLOOR and apply an even generous coat. Allow to dry 3-4 hours. Lightly sand the surface and dust off. Apply second coat. Do not leave more than 12 hours between the 1st and 2nd coat. 2- Two component finish : mix 1 part of UFL hardener to 10 parts of ULTIMAFLOOR. After 5min apply an even generous coat. Allow to dry 4 hours. Lightly sand the surface and dust off. Apply second coat. Do not leave more than 12 hours between the 1st and 2nd coat
DESIRED APPEARANCE : Clear Satin
Proud Members of International Thermo Wood Association 
- Site created by adfields.solutions
© OWATROL - Groupe DURIEU - 29 avenue du Roule - 92200 Neuilly s/Seine (France) - Phone: +33 (0)1 82 88 83 65 - Fax : +33 (0) 160 86 84 84