BAAAGD
Reference : BAAAGDen
:
- :
TVA 19.6%19.6%
CONDITION : New and bare
DESIRED FINISH : Solvent based saturating oil
SUPPORT : Wood
SITUATION : Exterior
TYPE : Exotic except iroko, padouk, azobe
EXPLICATIF : Ensure weather conditions are compatible with application of the product.
The surface must be clean, dry and in sound condition.
PREPARATION: Conduct a water drop test: sprinkle a few drops of water on the wood. If water penetrates quickly the finish can be applied. If the water sits on the surface or beads up then the grain of the wood is not sufficienlty open to apply the finish. It is then necessary to prepare it with one of two solutions: 1-Sand the wood with (grit 80/100 max) abrasive. Thoroughly dust off. 2-For direct application, apply AQUANETT to dry wood. Scrub with a synthetic brush, allow it to stand 5min, rinse with fresh water. After rinsing immediately apply NET-TROL to the wet wood. Scrub with a synthetic brush, allow it stand between 10 and 20min, rinse with fresh water. Allow wood to dry 3 good drying days before applying the finish.
APPLICATION: Apply one coat of tinted D.1 PRO, allow it to penetrate 15-30min max, apply second coat. Allow it to penetrate. Wipe off or brush out excess product to avoid it drying as a shiny finish on the surface. Allow it dry 24 hours without rain.
The surface must be clean, dry and in sound condition.
PREPARATION: Conduct a water drop test: sprinkle a few drops of water on the wood. If water penetrates quickly the finish can be applied. If the water sits on the surface or beads up then the grain of the wood is not sufficienlty open to apply the finish. It is then necessary to prepare it with one of two solutions: 1-Sand the wood with (grit 80/100 max) abrasive. Thoroughly dust off. 2-For direct application, apply AQUANETT to dry wood. Scrub with a synthetic brush, allow it to stand 5min, rinse with fresh water. After rinsing immediately apply NET-TROL to the wet wood. Scrub with a synthetic brush, allow it stand between 10 and 20min, rinse with fresh water. Allow wood to dry 3 good drying days before applying the finish.
APPLICATION: Apply one coat of tinted D.1 PRO, allow it to penetrate 15-30min max, apply second coat. Allow it to penetrate. Wipe off or brush out excess product to avoid it drying as a shiny finish on the surface. Allow it dry 24 hours without rain.
DESIRED APPEARANCE : Transparent Matt
Proud Members of International Thermo Wood Association 
- Site created by adfields.solutions
© OWATROL - Groupe DURIEU - 29 avenue du Roule - 92200 Neuilly s/Seine (France) - Phone: +33 (0)1 82 88 83 65 - Fax : +33 (0) 160 86 84 84