XYLIN
Waterborne saturating oil for interior wood
 Coverage per coat: 15 to 20 m²/l |
 Application temperature: +5°C to +35°C |
 Drying time: 2 hours (approximately) |
PROPERTIES
Clear - Fast drying - Odourless
Accentuates the natural wood grain and colour
Non film-forming. Easy to use
Excellent penetration of the surface.
Reinforced water resistance - Protects against stains.
WHERE TO USE
- Interior.
- direct on prepared woods
- "Vertical and horizontal surfaces - panelling, beams, roofs, worktops, staircases...
- New or old wood :
- Exotic hardwood : Teak, Ipe, Padouk...
- Softwood : Spruce, Pine, Cedar, Larch...
- Hardwoods : Oak, Chestnut...
- Heat treated wood
RECOMMENDATIONS BEFORE Application
- Wood must be clean, dry and free of dirt, grease and any previous coatings
- New wood does not require any special preparation
- Aged, stained or discoloured wood should be cleaned and degreased
- Remove all previous coatings by sanding or stripping with CDKP 90.
- Some untreated softwoods may need to be treated with the preservative TMU 84 to protect against possible fungal attack or blue stain. Naturally durable and heat treated woods do not need a preservative treatment.
- Do not dilute XYLIN.
Application
- Mix thoroughly before and periodically during application.
- Apply a liberal application of XYLIN working in direction of grain and working an area that you can complete in 20 min.
- Apply 2nd application as soon as wet look of 1st application has disappeared and allow to penetrate (15-20 minutes).
- Brush out any excess that has not penetrated, to areas where product has penetrated, in order to avoid drips, runs and XYLIN drying as shiny spots on the surface. XYLIN place is in the wood, not on the surface.
- After spray application, always back-brush or back-roll to improve penetration, coverage and uniformity of finish.
- Do not allow XYLIN to become Touch Dry or Dry between applications.
- Refer to technical data sheet for detailed application instructions
Proud Members of International Thermo Wood Association 
- Site created by adfields.solutions
© OWATROL - Groupe DURIEU - 29 avenue du Roule - 92200 Neuilly s/Seine (France) - Phone: +33 (0)1 82 88 83 65 - Fax : +33 (0) 160 86 84 84