search
search
This product is available in the following families
OWAYELL
Gelcoat and metal renovator
 Application température : +5°C to +30°C |
PROPERTIES
Removes yellow staining, mould, black stain and rust.
Brightens and whitens gelcoats.
Dissolves limescale, sea salt and water marks.
Cleans and renews anti-slip surfaces.
Disintegrates dirt caused by micro-organisms and barnacle/shell residue.
Removes streaks and rust traces. Passivates steel.
Restores shine to stainless steel (removes rust spots), anodised aluminium and chromes surfaces.
Easy to use and fast acting.
WHERE TO USE
- Polyester/Gelcoat, Anodised Aluminium, Plexiglass, Glass, Stainless Steel...
- Hull, Keel, Propeller Shaft...
- Decks, Portholes, Pulpits, Stanchions, Cleats, Chocks, Rigging...
- Masts, Spars...
RECOMMENDATIONS BEFORE Application
- Protect surfaces you do not wish to treat.
- Do not apply to surfaces in direct sunlight during the hottest hours of the day.
- Limit contact time to 5 minutes when applying to paint, varnish, lacquer or non-rusted steel.
- Always test on a small inconspicuous area first.
- Use appropriate protective clothing - Gloves, Goggles...
Application
- Shake well before use.
- Do not dilute.
- Apply OWAYELL to the surface to be treated.
- Allow to work 5 to 10 minutes (20°C @ 50 % RH). No need to scrub surface.
- Rinse with plenty of fresh clean water, working from top to bottom.
- If required repeat process.
- TIP: For surfaces heavily encrusted with limescale brush surface with nylon brush 10 minutes after applying first application. DO NOT rinse. Apply 2nd application and leave to work 5 to 10 minutes. Rinse with plenty of fresh clean water.
ADDITIONAL USES
- Liquid sander to passivate raw steel and aluminium before painting.
- Dilute 1 part OWAYELL to 5 parts water.
- Apply to surface and leave to work 10 minutes.
- Rinse off.
- Dry and immediately apply finish.
Recommendations after Application
- Store left over product in original container
- Keep from freezing and high temperatures.
our Advice
- Lors d'un très fort encrassement avec présence importante de calcaire, après 15 mn d'application, brosser à l'aide d'une brosse nylon, puis appliquer une nouvelle couche d'OWAYELL sans rinçage entre les 2 applications. Reprendre alors le mode opératoire (action 10 à 15 mn puis rinçage à grande eau).
- Autre utilisation d'OWAYELL :
- En tant que ponçage chimique avant application de la finition. Prépare les aciers et l'aluminium bruts en créant une passivation.
- Diluer 1 volume d'OWAYELL pour 5 volumes d'eau. Laisser agir 15 minutes puis rincer soigneusement. Sécher puis appliquer immédiatement une finition de type peinture, laque...
Related Products
Proud Members of International Thermo Wood Association 
- Site created by adfields.solutions
© OWATROL - Groupe DURIEU - 29 avenue du Roule - 92200 Neuilly s/Seine (France) - Phone: +33 (0)1 82 88 83 65 - Fax : +33 (0) 160 86 84 84